49.5
Test Call Configuration Examples
Below are a few examples of test call configurations.
Single Test Call Scenario: This example describes the configuration of a simple test
call scenario that includes a single test call between a simulated test endpoint on the
device and a remote endpoint.
Test Call table configuration:
Alternatively, if you want to route the test call using the Outbound IP Routing table for
the Gateway / IP-to-IP application, configure the following:
Test Call table configuration:
Outbound IP Routing table configuration:
User's Manual
Figure 4 9-7: Single Test Call Example
Endpoint URI: "101"
Called URI: "201"
Route By: Dest Address
Destination Address: "10.30.40.01"
Call Party: Caller
Test Mode: Once (default)
Endpoint URI: 101@10.0.0.1
Route By: GW Tel2IP
Called URI:
201@10.30.40.1
Call Party: Caller
Dest. Phone Prefix: 201 (i.e., the Called URI user-part)
Source Phone Prefix: 101 (i.e., the Endpoint URI user-part)
Dest. IP Address: 10.30.40.1
636
Mediant 800B GW & E-SBC
Document #: LTRT-10274