13.2 Setting the stroke movement for the feeding foot
For correct feed, the stroke movement for the feeding foot must be aligned
to the stroke movement for the feed-dog.
Sequence
First check the following settings:
• Feed-dog movement
• Even sewing foot stroke (
Correct setting
Left adjusting wheel for the sewing foot stroke set to 9 and the upper stitch
length adjusting wheel to 0:
Figure 45: Stroke movement for the feeding foot and feed-dog
Cover
• Arm cover (
58
WARNING
Risk of injury
Switch the sewing machine off before you check and set the
stroke movement for the feeding foot.
(
Section 9.2 Setting the feed-dog movement, page 37)
stroke, page 57)
The feeding foot (1) touches down exactly on the feed-dog (2) when
the downwards movement of the needle tip (3) reaches the upper
edge of the feeding foot. This will occur when the handwheel is in the
95° position.
(1) - Feeding foot
(2) - Feed-dog
Section 4.4.2 Removing and fitting the arm cover,
page 11)
Section 13.1 Setting an even sewing foot
(3) - Needle tip
Service manual H867 Version 00.0 - 08/2013
Sewing feet