Command Line Interface; Connecting To The Switch Console; Default User Name And Password; Terminal Settings - HP Moonshot-45XGc User And Maintenance Manual

Command Line Interface

Connecting to the switch console

To connect to the switch console, use one of the following methods:
•
To connect locally, use the serial console port
•
To connect remotely, be sure the management network is connected to the iLO CM management port
("Accessing the CLI
•
To connect using iLO, use the virtual serial port from the iLO CLI
22).

Default user name and password

No user name or password is required to login to the switch by default.

Terminal settings

Use the following terminal settings when connecting to the serial console port
module components" on page 6):
•
115200 baud rate
•
8 data bits
•
No parity
•
1 stop bit
•
No flow control

Accessing the CLI locally

If using a PC with a terminal emulator, be sure a terminal emulator is installed before communicating with the
switch.
Use a console cable to connect a PC or terminal to the serial console port on the uplink module.
1.
("Moonshot-4QSFP uplink module
Configure the terminal settings (on page 21).
2.
Start the terminal.
3.
The switch prompt appears.
remotely" on page 22).
components" on page 6)
("Accessing the CLI locally" on page 21).
("Accessing the CLI using iLO" on page
("Moonshot-4QSFP uplink
Command Line Interface 21