Rev #23
MOVE DN is used to move the selected point downwards within task.
•
5.7.2.1
View options
There are three different views of creating task: list view, detailed list view and map view.
Press the VIEW button and scroll to desired mode to change the method (don't click ok).
List is your default mode that displays task distance, start, turn and finish points, together
with bearing and time (for AAT tasks). Detailed list view is same in all aspects except it also
enables you to see coordinates of each point. Map view allows you to view the task on the
map and edit zones by scrolling over them (use upper and lower rotatory knobs to do so). If
option FAI area is enabled under MAP options (see chapter 6.2.1.1), you will also see this
area here. When using this view, it is usually faster and easier to first create task in one of
the previously described views and then only edit it in map view.
5.7.2.2
Starts (Multiple Start Points)
In some competitions, multiple start points are used for start. Press the STARTS button to
open the multiple starts dialogue.
The first start point will be greyed out. This is point which is defined in task. Add as many
start points as required. Subsequently it is possible to cycle through the start points via the
CYCLE button.
Version 7.10
December 2019