View Options; Starts (Multiple Start Points) - LXNAV LX90 Series Manual

Rev #1
• MOVE UP is used to move the selected point upwards within the route.
• MOVE DN is used to move the selected point downwards within route.

5.7.2.1 View options

There are three different views of creating route: list view, detailed list view and map
view. Press the VIEW button and scroll to desired mode to change the method (don't click
ok). List is the default mode that displays route distance, start, turn and finish points,
together with bearing and time (for AAT tasks). Detailed list view is same in all aspects
except it also enables you to see coordinates of each point. Map view allows you to view
the task on the map and edit zones by scrolling over them (use upper and lower rotatory
knobs to do so). If option FAI area is enabled under MAP options (see Section 6.2.1.1),
you will also see this area here. When using this view, it is usually faster and easier to first
create a route in one of the previously described views and then only edit it in map view.

5.7.2.2 Starts (Multiple Start Points)

In some competitions multiple start points are used for the start. Press the STARTS button
to open the multiple starts dialogue.
The first start point will be greyed out. This is point which is defined in route. Add as many
start points as required. Subsequently it is possible to cycle through the start points via the
CYCLE button.
Version 7.10
Page 105 of 145
January 2020