Table of Contents
Advertisement
LX90xx/LX80xx Version 5.0
TE compensation can be selected to be either pneumatic TE probe or digital
compensation.
2.1.5
Interfaces
The RS232 interface has NMEA output for external devices.
An SD Card interface.
A USB slot for data transfer using USB memory stick.
2.1.6
Internal Options
Flarm module can be built into the main display unit.
available on the rear side of the unit (Flarm external indicator, Flarm antenna), which
guaranties the same comfort as with the original Flarm devices. It is very important to point
out that the whole system uses only one GPS receiver and therefore offers a low power
solution.
Artificial horizon can be enabled on main display unit. Vario sensor box is constantly
using data from inertial platform in order to make vario signal smoother, however if pilot
would like to see artificial horizon and software option to do so must be purchased.
2.1.7
External Options
By using a RS485 bus system a wide range of optional interfaces can be easily connected to
the basic configuration with minimal installation work.
extended easily by use of RS485 splitting units, which allow plug and play connection of
optional devices. The following units can be connected to the main system:
Second Seat Device (LX9000D, LX9050D LX9070D LX8000D or LX8080D):
The unit installed in the rear seat of the glider is powered and receives all necessary
The LXNAV bus system can be
Page 12 of 166
All necessary connectors are
June 2015
Advertisement
Table of Contents
