4.9 CO & Incoming Call [9]
Intercept when the destination is Busy
Enables the Intercept Routing—Busy feature to activate when the original destination is busy.
Default
Value Range
Feature Guide References
Feature References
•
Programming References
•
Intercept when the destination sets DND
Enables the Intercept Routing—DND feature to activate when the original destination is in DND
mode.
Default
Value Range
Feature Guide References
Feature References
•
Programming References
•
Routing to Operator when the destination is not programmed
Enables the Intercept Routing—No Destination feature to activate when there is no destination
for the call. (The Intercept Routing—No Destination feature always works for the calls through
LCOT card, even when this feature is disabled.)
Default
Value Range
Feature Guide References
Feature References
•
Programming References
•
456
Feature Guide
Disable (Busy Tone)
Disable (Busy Tone): Sends busy tone to the caller (However, a call
through LCOT card will ring at the original destination while the
caller hears a ringback tone.)
Enable: Redirects the call to the intercept destination
1.1.1.4 Intercept Routing
None
Enable
Disable (Busy Tone): Sends busy tone to the caller (However, a call
through LCOT card will ring at the original destination while the
caller hears a ringback tone.)
Enable: Redirects the call to the intercept destination
1.1.1.4 Intercept Routing
None
Enable
Disable (Reorder Tone): Sends the reorder tone to the caller
Enable: Redirects the call to an operator
1.1.1.5 Intercept Routing—No Destination
None