Operator Features - Panasonic KX-TAW848 Features Manual

2.2 System Configuration—Software
Conditions
• The start times of the following time modes can be specified through PC programming as
well as PT programming (
The start and end times of the following break modes can be specified through PC
programming only.
Note that if an end time is programmed for a break, the day mode will start or resume at
this time, as shown previously in "Visualization of Time Schedule for Tenant 1" example.
If no end time is programmed, the break will continue until the start of the next time mode,
as shown in Time Table 4 in "Visualization of Time Schedule for Other Tenants".
• Time Service Switching Mode (Automatic/Manual) Button
Any flexible button can be customized as the Time Service Switching Mode (Automatic/
Manual) button.
Feature Guide References
1.8.1 Toll Restriction (TRS)
1.18.2 Flexible Buttons
2.2.3 Tenant Service
User Manual References
User Manual
1.7.7 Time Service
2.1.2 Time Service Mode Control
2.2.5

Operator Features

Description
This PBX supports separate operators for both the PBX and each tenant. Any extension or
incoming call distribution (ICD) group can be designated as an operator. Operators are the
destination of Operator Calls.
Type
PBX operator
180 Feature Guide
– Day 1 and 2
– Lunch
– Night
– Break 1
– Break 2
– Break 3
A different extension or ICD group can be assigned as a PBX
operator for each time mode (
Time Service Starting Time [102]).
Description
Operator Assignment [006]).