Panasonic KX-TAW848 Features Manual page 140

1.19 Voice Mail Features
[DTMF Status Signals]
Status
Ringback Tone
Busy Tone
Reorder Tone
DND Tone
Answer
Confirm
Disconnect
FWD to VM
Ringback Tone
FWD to VM Busy
Tone
FWD to Extension
Ringback Tone
System Programming
The service mode for each VM (DTMF) group and various DTMF settings must be
programmed through system programming to match the settings of your VPS. If the settings of
the PBX and your VPS do not agree, the VPS will not perform as expected.
1.
Service Mode Assignment
Through system programming, assign a service mode (VM or AA) to each VM (DTMF)
group to match the settings of your VPS.
2.
DTMF Status Signal Assignment
When using AA service, the PBX will communicate with your VPS by sending DTMF tones
to indicate the status of PBX extensions. Assign these DTMF status signals through PBX
system programming to match the settings of your VPS.
3.
DTMF Command Assignment
The PBX also sends DTMF tones to your VPS to command the VPS to play or record
messages, or to switch between VM and AA service modes. Assign these DTMF
commands through PBX system programming to match the settings of your VPS.
4.
Redirecting Calls to the VPS via FWD or Intercept Routing
When a call is redirected to the VPS via FWD or Intercept Routing it will be redirected to
either the VM service or the AA service of your VPS, based on system programming. This
allows a caller to, for example, be connected to an extension via AA service, then be
connected to that extension's mailbox if the extension does not answer.
140 Feature Guide
Condition
The PBX is ringing the corresponding extension.
The called extension is busy.
The dialed number is invalid.
The called extension has set Do Not Disturb
(DND). ( 1.3.1.3 Do Not Disturb (DND))
The called extension has answered the call.
The PBX confirms that a feature (such as
Message Waiting) has been set or canceled on
the extension.
The caller has hung up.
The called extension has set FWD to VPS and
the PBX is calling another port of the VPS.
The called extension has set FWD to VPS and all
ports of the VPS are busy.
The PBX is calling an extension other than the
one dialed, most likely because the called
extension has set its calls to be forwarded to
another extension or because it is a member of
an idle extension hunting group. (
Extension Hunting)
Default DTMF
Status Signal
1.2.1 Idle
1
2
3
4
5
9
#9
6
7
8