Panasonic KX-TAW848 Features Manual page 379

Feature Guide References
Feature References
• None
Programming References
• 4.1.11 Extension Port [1-5]
Extension Number
Specifies the extension number of the extension.
To change the extension number of a wired extension, follow the steps below:
1.
Type the new extension number, then click Apply.
2.
Set the status of the extension port to "OUS", then "INS".
When changing the extension number, make sure that the extension port is not in use. If the
extension number is changed while the port is in use, the new extension number will not come
into effect.
Default
Value Range
Feature Guide References
Feature References
• None
Programming References
• 4.1.12 Extension Port [1-5] Port Command
Extension Name
Specifies the name of the extension. As for the available characters, refer to the character code
table described in section 3.2.1 Installing and Starting KX-TAW848 Maintenance Console.
Default
Value Range
Feature Guide References
• None
Extension Caller ID
Enables the extension to send Caller ID information to an SLT.
Note that the setting of this parameter is only effective when a resource for sending extension
Caller ID is assigned in Extension Caller ID Resource-1, 2 for the port in Extension Caller
ID [2-11].
Default
Value Range
Feature Guide References
Feature References
• 1.16.1 Caller ID
Starting at 101 (For port 01 of the first extension card that is
installed. Extension numbers are preset for subsequent extensions
by adding one to the previous extension number.)
Max. 4 digits (consisting of 0–9)
Not stored.
Max. 20 characters
Disable
Disable, Enable
4.4 Extension [4]
Feature Guide 379