Reconfigure The Network Access Using A Serial Connection; Reconfigure The Network Access Using The Ethernet Connection; Use The Ipmitool Commands When Sp Network Information Is Lost - Oracle Exalogic Elastic Cloud Owner's Manual

7.7.1 Reconfigure the Network Access Using a Serial Connection

Connect to the ILOM using a serial connection, as described in
1.
via a Serial
Run the following commands at the ILOM command prompt:
2.
set pendingipdiscovery=static
set pendingipaddress=<ip_address>
set pendingipnetmask=<ip_netmask>
set pendingipgateway=<ip_gateway>
set pendingmanagementport=/SYS/MB/NET0
set commitpending=true

7.7.2 Reconfigure the Network Access Using the Ethernet Connection

Connect to the ILOM using the Ethernet connection, as described in
1.
ILOM via the
Run the following commands at the ILOM command prompt:
2.
set pendingipdiscovery=static
set pendingipaddress=<ip_address>
set pendingipnetmask=<ip_netmask>
set pendingipgateway=<ip_gateway>
set pendingmanagementport=/SYS/MB/NET0
set commitpending=true

7.7.3 Use the Ipmitool Commands when SP Network Information is Lost

If the service processor (SP) network information gets lost, you can use an SSH shell to
connect to the ETH0 interface of the operating system on the compute node and run
appropriate ipmitool commands to reconfigure network settings, as in the following
example:
/opt/ipmitool/bin/ipmitool sunoem cli 'set /SP/users/
rootpassword=somepasswd' somepasswd
This example resets the ILOM root password.
Connection.
Network.
Note:
An Ethernet cable is pre-wired in the Exalogic machine for this purpose.
Note:
For more information about ipmitool commands and options, navigate to
the /opt/ipmitool/bin/ directory and run man ipmitool.
Reconfigure the Network Access
Connect to ILOM
Connect to
Set Up ILOM on the Compute Nodes 7-7