Oracle Exalogic Elastic Cloud Owner's Manual page 161

• step 17 in Set Up Ethernet Over InfiniBand on Oracle Solaris
• second command in step 10 in
Solaris 11.2
Run the following command on the gateway switch CLI, as root, to verify the
4.
VNICs:
# showvnics
The following message is displayed:
ID STATE FLG IOA_GUID
--- -------- --- ----------------------- ---------- ---- -------------
0 UP N 00:21:28:00:01:A0:A6:95 computenode1 EL-C 192.168.10.29
0000 62:C0:A0:A8:01:05 NO ffff
1 UP H 00:21:28:00:01:A0:A6:95 computenode1 EL-C 192.168.10.29
8001 62:C0:A0:A8:01:02 10 ffff
2 UP H 00:21:28:00:01:A0:A6:95 computenode1 EL-C 192.168.10.29
8002 62:C0:A0:A8:01:03 11 ffff
Note that the VNIC with ID 0 corresponds to an already created network-
administered VNIC (created using the steps described in
InfiniBand (EoIB) on Oracle
the ones with IDs 1 and 2 (with VLANs 10 and 11, respectively).
Tip:
After creating the interfaces, you can run the dladm command to verify the
MAC address on the compute node. For example, to verify the new interface
and its MAC address, run one of the following commands on the Oracle
Solaris compute node for which the VNIC was created:
# dladm show-vnic eoib0_v10
The output of this command shows the MAC address, which is the MAC
address you defined for the VNIC.
If you want to configure the VNIC interfaces in an IPMP group on Oracle Solaris,
5.
for high availability purposes, perform on of the following procedures depending
on the OS version:
• step 18 in Set Up Ethernet Over InfiniBand on Oracle Solaris
• step 14 in Set Up Ethernet Over InfiniBand on Oracle Solaris 11.2
Oracle Solaris: Creating VNICs and Associating Them with VLANs
Set Up Ethernet Over InfiniBand on Oracle
NODE IID
1A-ETH-3
1A-ETH-3
1A-ETH-3
Solaris). The two new host-administered interfaces are
11.1.
MAC VLN PKEY GW
Set Up Ethernet Over
11.1.
Set Up Virtual LANs 11-5