Delete A Partition; Create A Partition For Eoib And Associating The Pkey With A Vnic And Vlan - Oracle Exalogic Elastic Cloud Owner's Manual

16.6 Delete a Partition

You can delete a non-default partition by running the following command:
# smpartition delete -n myIPoIB
This command deletes the myIPoIB partition.
16.7 Create a Partition for EoIB and Associating the pkey with a VNIC and
VLAN
You can create a partition for EoIB (both inbound and outbound) and associate the
partition's pkey with a VLAN and VNIC on the edge network.
At the command prompt on one of the gateway switches, run the following
1.
command:
el01gw04# listlinkup | grep Bridge
The following is an example of the output of the lislinkup command:
Connector 0A-ETH Present
From this example, identify the uplinks. You can determine that you can use any
of the following Ethernet connectors for creating a VNIC:
•
•
•
•
•
•
Note:
Do not attempt to delete the default partition.
Note:
The port GUID values, MAC addresses, VLAN IDs, compute node names,
gateway switch names, and Ethernet connector names used in this procedure
are examples only.
Bridge-0 Port 0A-ETH-1 (Bridge-0-2) up (Enabled)
Bridge-0 Port 0A-ETH-2 (Bridge-0-2) up (Enabled)
Bridge-0 Port 0A-ETH-3 (Bridge-0-1) up (Enabled)
Bridge-0 Port 0A-ETH-4 (Bridge-0-1) up (Enabled)
Bridge-0 Port 1A-ETH-1 (Bridge-1-2) down (Enabled)
Bridge-0 Port 1A-ETH-2 (Bridge-1-2) down (Enabled)
Bridge-0 Port 1A-ETH-3 (Bridge-1-1) up (Enabled)
Bridge-0 Port 1A-ETH-4 (Bridge-1-1) up (Enabled)
0A-ETH-1
0A-ETH-2
0A-ETH-3
0A-ETH-4
1A-ETH-3
1A-ETH-4
Use InfiniBand Partitions in Exalogic Physical Environments 16-9
Delete a Partition