Oracle Exalogic Elastic Cloud Owner's Manual page 19

– Cabling Diagrams
– Replacement Units: Added note about the spares kit for Exalogic.
– Cabling Tables: Corrected errors in the networking tables.
• E18478-12: February 2013
– Parts for Sun Server X3-2 Compute
numbers of the new BBU.
– Create an IPoIB Partition and Adding
command syntax in step 3.
• E18478-11: December 2012
– Hardware Components of
X2-2 and X3-2 data sheets.
– Environmental
and X3-2 data sheets.
• E18478-10: October 2012
– Environmental
– Create an IPoIB Partition and Adding
storage appliance when creating IB partitions.
– Chapter 16, "Monitoring the Exalogic Machine Using Oracle Enterprise
Manager Ops Center": Added information, up front, to clarify the scope of the
content in this chapter.
– Replacement Units: Added replacement parts list for the new hardware
components in X3-2.
– Rebranded the document cater to both X3-2 and X2-2.
• E18478-09: September 2012
– Configure Ethernet Over
Updated the procedure to set up EoIB on Oracle Linux and Oracle Solaris, to
correct certain errors and inconsistencies.
Added information about the recommended naming convention for VNICs
on Oracle Linux.
– Subnet Manager Operation in Different Rack
Updated Table 13-1
Added information for running the SM in rack configurations with varying
switch-firmware versions.
– Create a Partition for EoIB and Associating the pkey with a VNIC and
Added information about the recommended naming convention for VNICs
on Oracle Linux.
– Configuration Tasks: Updated with information about contacting Oracle
Advanced Customer Support.
: Added additional Exalogic wiring configurations.
Nodes: Added the replacement part
Ports: Corrected the smpartition
Exalogic: Added generic link that points to both
Requirements: Added generic link that points to both X2-2
Requirements: Added environmental requirements for X3-2.
Ports: Added steps for configuring the
InfiniBand:
to make the information clearer.
Configurations:
VLAN:
xix