Dell C9000 Series Networking Configuration Manual page 65

CONFIGURATION mode
privilege exec level level configure
• Allow access to INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode. Specify all the keywords in the
command.
CONFIGURATION mode
privilege configure level level {interface | line | route-map | router}
{command-keyword ||...|| command-keyword}
• Allow access to a CONFIGURATION, INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode command.
CONFIGURATION mode
privilege {configure |interface | line | route-map | router} level level
{command ||...|| command}
Example of EXEC Privilege Commands
The configuration in the following example creates privilege level 3. This level: removes the resequence
command from EXEC mode by requiring a minimum of privilege level 4 moves the capture bgp-pdu max-
buffer-size command from EXEC Privilege to EXEC mode by requiring a minimum privilege level 3, which
is the configured level for VTY 0 allows access to CONFIGURATION mode with the banner command allows
access to INTERFACE and LINE modes are allowed with no commands.
Dell(conf)#do show run priv
!
privilege exec level 3 capture
privilege exec level 3 configure
privilege exec level 4 resequence
privilege exec level 3 capture bgp-pdu
privilege exec level 3 capture bgp-pdu max-buffer-size
privilege configure level 3 line
privilege configure level 3 interface
Dell(conf)#do telnet 10.11.80.201
[telnet output omitted]
Dell#show priv
Current privilege level is 3.
Dell#?
capture Capture packet
configure Configuring from terminal
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from the EXEC
ip Global IP subcommands
monitor Monitoring feature
mtrace Trace reverse multicast path from destination to source
ping Send echo messages
quit Exit from the EXEC
show Show running system information
[output omitted]
Dell#config
[output omitted]
Dell(conf)#do show priv
Current privilege level is 3.
Dell(conf)#?
end
exit
interface
line
linecard
Dell(conf)#interface ?
Exit from configuration mode
Exit from configuration mode
Select an interface to configure
Configure a terminal line
Set line card type
Switch Management 65