Ip Fragment Handling - Dell C9000 Series Networking Configuration Manual

Determine the Order in which ACLs are Used to Classify
Traffic
When you link class-maps to queues using the service-queue command, the system matches the class-
maps according to queue priority (queue numbers closer to 0 have lower priorities).
As shown in the following example, class-map cmap2 is matched against ingress packets before cmap1.
ACLs acl1 and acl2 have overlapping rules because the address range 20.1.1.0/24 is within 20.0.0.0/8.
Therefore (without the keyword order), packets within the range 20.1.1.0/24 match positive against cmap1
and are buffered in queue 7, though you intended for these packets to match positive against cmap2 and be
buffered in queue 4.
In cases such as these, where class-maps with overlapping ACL rules are applied to different queues, use the
order keyword to specify the order in which you want to apply ACL rules. The order can range from 0 to
254. The system writes to the CAM ACL rules with lower-order numbers (order numbers closer to 0) before
rules with higher-order numbers so that packets are matched as you intended. By default, all ACL rules have
an order of 254.
Example of the
order
Dell(conf)#ip access-list standard acl1
Dell(config-std-nacl)#permit 20.0.0.0/8
Dell(config-std-nacl)#exit
Dell(conf)#ip access-list standard acl2
Dell(config-std-nacl)#permit 20.1.1.0/24 order 0
Dell(config-std-nacl)#exit
Dell(conf)#class-map match-all cmap1
Dell(conf-class-map)#match ip access-group acl1
Dell(conf-class-map)#exit
Dell(conf)#class-map match-all cmap2
Dell(conf-class-map)#match ip access-group acl2
Dell(conf-class-map)#exit
Dell(conf)#policy-map-input pmap
Dell(conf-policy-map-in)#service-queue 7 class-map cmap1
Dell(conf-policy-map-in)#service-queue 4 class-map cmap2
Dell(conf-policy-map-in)#exit
Dell(conf)#interface tengig 1/0
Dell(conf-if-te-1/0)#service-policy input pmap

IP Fragment Handling

The system supports a configurable option to explicitly deny IP fragmented packets, particularly second and
subsequent packets.
It extends the existing ACL command syntax with the fragments keyword for all Layer 3 rules applicable to
all Layer protocols (permit/deny ip/tcp/udp/icmp).
• Both standard and extended ACLs support IP fragments.
• Second and subsequent fragments are allowed because a Layer 4 rule cannot be applied to these
fragments. If the packet is to be denied eventually, the first fragment would be denied and hence the
packet as a whole cannot be reassembled.
• Implementing the required rules uses a significant number of CAM entries per TCP/UDP entry.
Keyword to Determine ACL Sequence
Access Control Lists (ACLs) 134