Table of Contents
Advertisement
CLI Command Mode
VRRP
UPLINK STATE GROUP
The following example shows how to change the command mode from CONFIGURATION mode to
PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
The do Command
Use the do command to enter an EXEC mode command from any CONFIGURATION mode
(CONFIGURATION, INTERFACE, SPANNING TREE, and so on.) without having to return to EXEC mode.
The following examples show how to use the do command in CONFIGURATION mode.
Dell#show ip interface brief
Interface
Protocol
TenGigabitEthernet 0/0
TenGigabitEthernet 0/1
TenGigabitEthernet 0/2
TenGigabitEthernet 0/3
TenGigabitEthernet 0/4
TenGigabitEthernet 0/5
TenGigabitEthernet 0/6
Dell#show version
Dell Real Time Operating System Software
Dell Operating System Version:
Dell Application Software Version:
Copyright (c) 1999-2015 by Dell Inc. All Rights Reserved.
Build Time: Mon Jun
Build Path: /build/build03/SW/SRC
Dell Networking OS uptime is 15 hour(s), 13 minute(s)
System image file is "system://A"
System Type: C9010
Control Processor: Intel Rangeley with 2 Gbytes (2127536128 bytes) of memory,
core(s) 2.
Route Processor: Intel
core(s) 2.
16G bytes of boot flash memory.
2 Route Processor Module.
3 24-port TE/GE (VG)
Prompt
Dell(conf-if-interface-
type-slot/port-vrid-vrrp-
group-id)#
Dell(conf-uplink-state-
group-groupID)#
IP-Address
unassigned
unassigned
unassigned
unassigned
unassigned
unassigned
unassigned
2.0
E9.9(0.0)
1 15:00:00 2015
Rangeley with 2 Gbytes (2127536128 bytes) of memory,
Access Command
vrrp-group
uplink-state-group
OK
Method Status
NO
Manual administratively down down
NO
Manual administratively down down
NO
Manual administratively down down
NO
Manual administratively down down
NO
Manual administratively down down
NO
Manual administratively down down
NO
Manual administratively down down
Configuration Fundamentals
45
Advertisement
Table of Contents
Troubleshooting
