Table of Contents
Advertisement
Navigating CLI Modes
The Dell Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI
mode. Move linearly through the command modes, except for the following:
•
end command which takes you directly to EXEC Privilege mode
•
exit command which moves you up one command mode level
NOTE:
Sub-CONFIGURATION modes all have the letters "conf" in the prompt with more modifiers to
identify the mode and slot/port information.
Table 1. Command Modes
CLI Command Mode
EXEC
EXEC Privilege
CONFIGURATION
NOTE:
Access all the
following modes from
CONFIGURATION mode.
Configuration Terminal Batch
DOT1X PROFILE
AS-PATH ACL
10 Gigabit Ethernet Interface
40 Gigabit Ethernet Interface
Interface Range
Loopback Interface
Management Ethernet Interface
Null Interface
Prompt
Dell>
Dell#
Dell(conf)#
Dell(conf-b)#
dell(conf-dot1x-profile)#
Dell(config-as-path)#
Dell(conf-if-te-0/0)#
Dell(conf-if-fo-0/0)#
Dell(conf-if-range)#
Dell(conf-if-lo-0)#
Dell(conf-if-ma-0/0)#
Dell(conf-if-nu-0)#
Access Command
Access the router through the
console or Telnet.
•
From EXEC mode, enter the
enable command.
•
From any other mode, use
the end command.
•
From EXEC privilege mode,
enter the configure
command.
•
From every mode except
EXEC and EXEC Privilege,
enter the exit command.
config terminal batch
dot1x
ip as-path access-list
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
Configuration Fundamentals
42
Advertisement
Table of Contents
Troubleshooting
