Configuring Timeouts - Dell C9000 Series Networking Configuration Manual

0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
203 Multicasts, 0 Broadcasts, 10760802177 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
2285 packets, 146240 bytes, 0 underruns
2285 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
1983 Multicasts, 0 Broadcasts, 302 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 76.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 03:21:48
View your configuration using the show config command from INTERFACE mode, as shown in the example
in Configuring a Guest VLAN
Example of Viewing Configured Authentication
802.1x information on Te 2/1:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts: 5
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Auth Type:
Auth PAE State:
Backend State:

Configuring Timeouts

If the supplicant or the authentication server is unresponsive, the authenticator terminates the authentication
process after 30 seconds by default. You can configure the amount of time the authenticator waits for a
response.
To terminate the authentication process, use the following commands.
• Terminate the authentication process due to an unresponsive supplicant.
INTERFACE mode
dot1x supplicant-timeout seconds
The range is from 1 to 300.
149280 packets/sec, 10.00% of line-rate
0 packets/sec, 0.00% of line-rate
or using the show dot1x interface command from EXEC Privilege mode.
Enable
FORCE_AUTHORIZED
UNAUTHORIZED
Disable
None
Disabled
200
Enabled
100
90 seconds
120 seconds
10
15 seconds
15 seconds
7200 seconds
10
SINGLE_HOST
Initialize
Initialize
802.1X 116