Layer 2 And Layer 3 Protocols; Management And Rmon; Packet Filters; Changes In Default Behavior And Syntax In Junos Release 10.2 For J-Ex Series Switches - Dell PowerConnect J-8208 Release Note

Layer 2 and Layer 3 Protocols

Management and RMON

Packet Filters

Related Topics

Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches

Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches

disable distributed PPM and run PPM just on the Routing Engine only if there is a
compelling reason to disable distributed PPM.
Enhancements to LCD menus—Using CLI commands, administrators can disable the
menu, the
Status Maintenance
from viewing certain details about the switch and from configuring and troubleshooting
the switch from the LCD menu.
IPv6 path maximum transmission unit discovery—The IPv6 path maximum
transmission unit (MTU) discovery feature is now available on J-EX8200 switches.
IPv6 virtual routing and forwarding (VRF) multicast—IPv6 multicast traffic is now
supported for VRF on J-EX4200, and J-EX8200 switches.
802.1ag OAM support on J-EX4200 switches—802.1ag is an IEEE standard for
connectivity fault management (CFM). The following features are supported: continuity
check protocol, linktrace protocol, and loopback protocols.
sFlow enhancements on J-EX Series switches—You can configure the IP address to
be assigned to the sFlow agent and the IP address to be used in sFlow datagrams. By
configuring the IP addresses, you can ensure that the IP addresses are not dynamic
and do not change when the switch restarts.
Enhancements to firewall filter actions supported on J-EX8200 switches—The
, and actions are now supported for ingress firewall filters on J-EX8200
reject syslog
switches. The action is supported on Layer 3 interfaces (router firewall filters)
reject
only.
Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches
on page 5
Limitations in JUNOS Release 10.2 for J-EX Series Switches on page 6
Outstanding Issues in JUNOS Release 10.2 for J-EX Series Switches on page 9
The following changes in system behavior, configuration statement usage, or operational
mode command usage have occurred since the previous release and might not yet be
documented in the JUNOS Software for J-EX Series switches documentation.

Access Control and Port Security

The following enhancements have been made to the
The show lldp local-information
management address and type.
menu, and the options in these menus to prevent users
show lldp
command now includes information about the local
log ,
commands:
5