Device Default Settings; Enabling Remote Management - Dell PowerConnect M8024 User Manual

Device Default Settings

To return to device default settings use delete startup-config command at the privileged
mode prompt (#), and reboot the device. Once device reloads – it is set with the default settings.
console>
console>enable
console#delete startup-config
Startup file was deleted
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n) y
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
Reloading all switches..

Enabling Remote Management

1. Enter the enable command at the console to enter the Privileged EXEC screen mode as follows:
console>enable
console#
2. Ensure that the management station is connected to the same network as the CMC. For more info see
Dell Blade Server CMC User's Guide.
the
3. Enter the config command at the console to enter the Configuration mode as follows:
console#config
4. Ensure that the switch has obtained an IP address using the show ip interface out-of-band command.
console#show ip interface out-of-band
IP Address..................................... 10.27.22.168
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.27.22.1
ServPort Configured Protocol Current........... DHCP
Configuring Dell PowerConnect
99