Save The Running-Configuration - Dell C9000 Series Networking Configuration Manual

Table 5. Forming a copy Command
Location
For a remote file location:
FTP server
For a remote file location:
TFTP server
For a remote file location:
SCP server
Important Points to Remember
• You may not copy a file from one remote system to another.
• You may not copy a file from one location to the same location.
• When copying to a server, you can only use a hostname if a domain name server (DNS) server is
configured.
• The usbflash command is supported on the device. Refer to your system's Release Notes for a list of
approved USB vendors.
Example of Copying a File to an FTP Server
Dell#copy flash://Dell-EF-8.2.1.0.bin ftp://myusername:mypassword@10.10.10.10/
/Dell/Dell-EF-8.2.1.0
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
27952672 bytes successfully copied
Example of Importing a File to the Local System
core1#$//copy ftp://myusername:mypassword@10.10.10.10//Dell/
Dell-EF-8.2.1.0.bin flash://
Destination file name [Dell-EF-8.2.1.0.bin.bin]:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied

Save the Running-Configuration

The running-configuration contains the current system configuration. Dell Networking recommends coping
your running-configuration to the startup-configuration.
The system uses the startup-configuration during boot-up to configure the system. The startup-configuration
is stored in the internal flash on the system by default, but it can be saved on a USB flash device or a remote
server.
The commands in this section follow the same format as those commands in the
Copy Files to and from the System
configuration. These commands assume that current directory is the internal flash, which is the system
default.
source-file-url Syntax
copy ftp://
username:password@{hostip
| hostname}/filepath/
filename
copy tftp://{hostip |
hostname}/filepath/
filename
copy scp://{hostip |
hostname}/filepath/
filename
section but use the filenames startup-configuration and running-
destination-file-url Syntax
ftp://
username:password@{hostip
| hostname}/ filepath/
filename
tftp://{hostip |
hostname}/filepath/
filename
scp://{hostip | hostname}/
filepath/filename
Getting Started 59