C: Tuning - YASKAWA CIMR-JC4A0002BAA Quick Start Manual

No. Name
DC Injection
Sets the DC Injection Braking current as a percentage
b2-02 Braking
of the drive rated current.
Current
DC Injection
b2-03 Braking Time/ Sets DC Injection Braking time at start. Disabled
DC Excitation when set to 0.00 seconds.
Time at Start
Sets DC Injection Braking time at stop.
DC Injection
When b1-03 = 0, this parameter sets the amount of
b2-04 Braking Time
DC Injection time applied to the motor at the end of
at Stop
the decel ramp. Disabled when set to 0.00.
u

C: Tuning

C parameters are used to adjust the acceleration and deceleration times, S-curves, slip and
torque compensation functions and carrier frequency selections.
No. Name
Use C1 parameters to configure motor acceleration and deceleration.
C1-01 Acceleration Sets the time to accelerate from 0 to maximum
<1> Time 1 frequency.
C1-02 Deceleration Sets the time to decelerate from maximum frequency
<1> Time 1 to 0.
Sets the time to accelerate from 0 to maximum
C1-03 Acceleration
frequency when Accel/Decel times 2 are selected by
<1> Time 2
a digital input.
Sets the time to decelerate from maximum frequency
C1-04 Deceleration
to 0 when Accel/Decel times 2 are selected by a
<1> Time 2
digital input.
Sets the time to decelerate from maximum frequency
C1-09 Fast-Stop to 0 for the multi-function input fast-stop function.
Time Note: This parameter is also used by selecting "Fast-
Stop" as a Stop Method when a fault is detected.
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
Description
Description
C1: Acceleration and Deceleration Times
C2: S-Curve Characteristics
Use C2 parameters to configure S-curve operation.
http://nicontrols.com
B.2 Parameter Table
Addr.
Range Def. Mode
Hex
0 to 75 50% O 18A
0.00 to 0.00
O 18B
10.00 s
0.00 to 0.50
O 18C
10.00 s
Addr.
Range Def. Mode
Hex
S
S
O
0.0 to 10.0
6000.0 s
O
O
Pg.
–
–
–
Pg.
200 93
201 93
202 93
203 93
208 –
B
213