YASKAWA CIMR-JC4A0002BAA Quick Start Manual page 221

B.2 Parameter Table
H1-oo
Function
Setting
0 3-Wire Sequence
1 LOCAL/REMOTE Selection
Serial Communication
2
Reference Selection
3 Multi-Step Speed Reference 1
4 Multi-Step Speed Reference 2
5 Multi-Step Speed Reference 3
6 Jog Reference Selection
7 Accel/Decel Time 1
8 Baseblock Command (N.O.)
9 Baseblock Command (N.C.)
A Accel/Decel Ramp Hold
F Not used
10 Up Command
11 Down Command
14 Fault Reset
15 Fast-Stop (N.O.)
17 Fast-stop (N.C.)
220
H1 Multi-Function Digital Input Selections
Closed: Reverse rotation (only if the drive is set up for 3-Wire
sequence)
Open: REMOTE, Run and frequency reference source set in
b1-01/02
Closed: LOCAL, LED operator is run and reference source
Open: REMOTE, Run and frequency reference source set in
b1-01/02
Closed: MEMOBUS/Modbus Communication
Used to select Multi-Step Speeds set in d1-01 to d1-08
Open: Selected speed reference
Closed: Jog Frequency reference (d1-17). Jog has priority over
all other reference sources.
Used to switch between Accel/Decel Time 1 and 2
Open: Normal operation
Closed: No drive output
Open: No drive output
Closed: Normal operation
Closed: The drive pauses during acceleration or deceleration
and maintains the output frequency.
Select this setting when not using the terminal or when using
the terminal in a pass-through mode.
Open: Maintains the current frequency reference
Closed: Increases or decreases the current frequency reference.
Ensure that the increase and decrease commands are set in
conjunction with one another.
Closed: Resets faults if the cause is cleared and the Run
command is removed.
Closed: Decelerates at the Fast-Stop time C1-09.
To restart the Fast-Stop input must be released and Run must
be cycled.
Open: Decelerates according to C1-09 (Fast-stop Time)
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
http://nicontrols.com
Description Page
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–