YASKAWA CIMR-JC4A0002BAA Quick Start Manual page 225

B.2 Parameter Table
No. Name
Selects the stopping method when a communication
time-out fault (CE) is detected.
Stopping
0: Ramp to stop
H5-04 Method After
1: Coast to stop
Comm. Error
2: Fast-stop
3: Alarm only
Enables or disables the communications timeout
fault (CE).
Comm. Fault
0: Disabled - A communication loss will not cause a
H5-05 Detection
communication fault.
Selection
1: Enabled - If communication is lost for more than
2 seconds, a CE fault will occur.
Drive
Set the wait time between receiving and sending
H5-06 Transmit Wait
data.
Time
Selects "request to send" (RTS) control:
RTS Control
H5-07 0: Disabled - RTS is always on.
Selection
1: Enabled - RTS turns on only when sending.
Run
Command 0: FWD/STOP, REV/STOP Method
H5-12
Method 1: RUN/STOP, FWD/REV Method
Selection
MEMOBUS
0: 0.1 Hz/1
Freq.
1: o1-03 based
H5-13 Reference and
2: 100%/30000
Freq. Monitor
3: 0.1%/1
Unit
<1> Parameter can be changed during run.
<2> If this parameter is set to 0, the drive will be unable to respond to MEMOBUS/Modbus commands.
Note: Cycle power to the drive to enable MEMOBUS/Modbus settings.
224
Description
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
http://nicontrols.com
Range Def. Mode
0 to 3 3 O
0, 1 1 O
10
10 to 65 O
ms
0, 1 1 O
0, 1 0 O
0 to 3 0 O
Addr.
Pg.
Hex
428 –
429 –
42A –
42B –
43D –
43E –