YASKAWA CIMR-JC4A0002BAA Quick Start Manual page 231

B.2 Parameter Table
No. Name
Sets the drive model.
o2-04 Drive Model
This parameter only needs to be set when installing a
Selection
new control board. Do not change for other reason.
Selects if the ENTER key must be pressed when
inputting the frequency reference by the operator
keypad.
Frequency
0: Data/Enter key must be pressed to enter a frequency
Reference
reference.
o2-05 Setting
1: Data/Enter key is not required. The frequency
Method
reference is adjusted by the UP and DOWN keys.
Selection
Note: When o2-05 is set to 1, the power supply to the
drive must remain on for at least 5 seconds after
making changes to the frequency reference.
Sets drive action when the digital operator is removed
Operation
in LOCAL mode or with b1-02 = 0 (valid for optional
Selection
remote operator only).
o2-06 when Digital
0: The drive will continue operation
Operator is
1: The drive will trigger a fault (oPr) and the motor
Disconnected
will coast to stop
o2-09 – Factory use.
Use o3 parameters to Read, Copy and Verify the parameter settings to and from the drive.
Selects the copy function operation.
0: No action
1: READ - All parameters are read from the drive and
stored in the LED operator.
Copy 2: COPY - All parameters are copied from the LED
o3-01 Function operator to the drive.
Selection 3: VERIFY - Parameter settings in the drive are
compared to those in the LED operator.
Note: When using the copy function, the drive model
number (o2-04) and the software number (U1-26)
must match or an error will occur.
Locks the READ operation to prevent accidental
Copy
overwriting of the data stored in the LED operator.
o3-02 Allowed
0: READ operation prohibited
Selection
1: READ operation allowed
Accumulated
Sets the value for the cumulative operation time of the
o4-01 Operation
drive in units of 10 h.
Time Setting
Determines, how the cumulative operation time
Accumulated
(U4-01) is counted.
Operation
o4-02 0: Logs power-on time
Time
1: Logs operation time when the drive output is active
Selection
(output operation time).
230
Description
o3: Copy Function
o4: Maintenance Period
Use o4 parameters to perform maintenance.
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
http://nicontrols.com
Addr.
Range Def. Mode
dep.
on
0 to FF O
drive
spec.
0, 1 0 O
0, 1 0 O
– – –
0 to 3 0 O
0, 1 0 O
0 to
0 O
9999
0, 1 0 O
Pg.
Hex
508 –
509 –
50A –
– –
515 –
516 –
50B –
50C –