European Standards; Ce Low Voltage Directive Compliance - YASKAWA CIMR-JC4A0002BAA Quick Start Manual

C.2

European Standards

The CE mark indicates compliance with European safety and environmental regulations and
is required for engaging in business and commerce in Europe.
European standards include the Machinery Directive for machine manufacturers, the Low
Voltage Directive for electronics manufacturers and the EMC guidelines for controlling noise.
This drive displays the CE mark based on the EMC guidelines and the Low Voltage Directive.
• EMC Guidelines: 2004/108/EC
• Low Voltage Directive: 2006/95/EC
u

CE Low Voltage Directive Compliance

This drive has been tested according to IEC61800-5-1:2007, and it fully complies with the
Low Voltage Directive.
To comply with the Low Voltage Directive, be sure to meet the following conditions when
combining this drive with other devices:
n
Area of Use
Do not use drives in areas with pollution higher than severity 2 and overvoltage category 3 in
accordance with IEC664.
n Installing Fuses on the Input Side
Always install input fuses that comply with UL standards to prevent the drive from short
circuits. Refer to Factory Recommended Drive Branch Circuit Protection on page 251
the appropriate fuse based on the maximum input of the drive.
Normal Duty Ratings on page 198
n Grounding
The drive is designed to be used in T-N (grounded neutral point) networks. If installing the
drive in other types of grounded systems, contact your dealer or Yaskawa for instructions.
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
Figure C.1 CE Mark
for information on drive input and output currents.
http://nicontrols.com
C.2 European Standards
Refer to Heavy Duty and
for
C
241