Alarms (Traps) - Hirschmann RS20 Reference Manual

Diagnostics

7.8 Alarms (Traps)

This dialog allows you to determine which events trigger an alarm (trap) and
where these alarms should be sent.
The following device types support 10 trap destinations:

RS20, RS30, RS40
 MS20, MS30
 In the "Configuration" frame, select the trap categories from which you
want to send traps. Default setting: all trap categories are active.
 Click on "Create".
 In the "IP Address" column, enter the IP address of the management
station to which the traps should be sent.
 In the column "Password", enter the community name that the device
uses to identify itself as the trap's source.
 In the "Enabled" column, you mark the entries that the device should take
into account when it sends traps. Default setting: inactive.
The events which can be selected are:
Name Meaning
Authentication The device has rejected an unauthorized access attempt
"SNMPv1/v2 Access
Link Up/Down At one port of the device, the link to another device has been
established/interrupted.
Spanning Tree The topology of the Rapid Spanning Tree has changed.
Table 128:Trap categories
RM GUI L2E
Release 8.0 05/2013
Settings").
7.8 Alarms (Traps)
(see on page 59
205