Hirschmann RS20 Reference Manual page 94

Time
Parameters Meaning
PTP Status Port is in the initialization phase.
Port is in the faulty mode. Error in the
PTP protocol.
PTP function is switched off at this
port.
Port has not received any
information and is waiting for
synchronization messages.
Port is in PTP pre-master mode.
Port is in PTP master mode.
Port is in PTP uncalibrated mode.
Port is in PTP passive mode.
Port is in PTP slave mode.
Sync Interval [s] Interval in seconds for the
synchronization messages
Runtime Mechanism for measuring the
Measuring message runtime.
Mechanism Enter the same mechanism for the
PTP device connected to this port.
A PTP slave port measures the
runtime of the entire transmission
path to the master. The device
displays the measured value in the
PTP:Version 2(BC):Global
dialog
The device measures the runtime to
all the PTP devices connected. If a
reconfiguration is performed, this
mechanism eliminates the need to
determine the runtime again,
provided all these devices support
P2P.
The MS20, MS30 and PowerMICE
devices with MM23 or MM33
modules, as well as the MACH 104
and MACH 1040 devices support
these mechanisms.
No runtime determination.
P2P Runtime Measured P2P (peer-to-peer)
runtime.
Prerequisite:
You have selected the P2P runtime
measuring mechanism.
Table 51: Port Dialog Version 2(BC)
94
(see on page 91 "Global").
3.3 PTP (IEEE 1588)
Possible values
initializing
faulty
disabled
listening
pre-master
master
uncalibrated
passive
slave
0,5; 1; 2
E2E (end-to-end):
P2P (peer-to-peer)
Disabled
Default setting
1
Disabled
RM GUI L2E
Release 8.0 05/2013