Hirschmann RS20 Reference Manual page 225

Advanced
Remote ID entry for DHCP server: 00 06 00 80 63 00 06 1E
Circuit ID: B3 06 00 00 01 00 01 01
This results in the entry for the "Hardware address" in the DHCP server:
B306000001000101000600806300061E
 The "DHCP-Relay on" activates the relay on the port. Clients connected
to an activated port communicate directly with a DHCP Server.
 The "DHCP-Relay Operation" shows the operating state of the relay on
the port.
 In the "Option 82 on" column in the table, you switch this function on/off
for each port.
 In the "Hirschmann Device" column, you check the ports connected to a
Hirschmann device.
Note: The DHCP relay function requires a minimum of 2 ports. Connect a
port to the DHCP client and a port to the DHCP server. Enable the DHCP
relay function globally and on the relay ports. The DHCP server function has
priority over the DHCP relay function. Therefore, disable the DHCP server
function on both the client and the server ports.
RM GUI L2E
Release 8.0 05/2013
8.1 DHCP Relay Agent
225