Basic Settings
Figure 9: Network parameters dialog
Under "Mode", you enter where the device gets its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device
"Load/Save").
In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device
"Load/Save").
In the local mode the net parameters in the device memory are used.
Enter the parameters on the right according to the selected mode.
You enter the name applicable to the DHCP protocol in the "Name" line in
the
Basic Settings:System
26
dialog of the graphical user interface.
1.3 Network
(see on page 38
(see on page 38
RM GUI L2E
Release 8.0 05/2013