Hirschmann RS20 Reference Manual page 47

Basic Settings 1.7 Load/Save
Note: The loading process started by DHCP/BOOTP (see on page 25
"Network") shows the selection of "from URL & save local" in the "Load"
frame. If you get an error message when saving a configuration, this could
be due to an active loading process. DHCP/BOOTP only finishes a loading
process when a valid configuration has been loaded. If DHCP/BOOTP does
not find a valid configuration, finish the loading process by loading the local
configuration from the device in the "Load" frame.
If you change the current configuration (for example, by switching a port off),
the graphical user interface changes the "load/save" symbol in the navigation
tree from a disk symbol to a yellow triangle. After saving the configuration,
the graphical user interface displays the "load/save" symbol as a disk again.
After you have successfully saved the configuration on the device, the device
sends a trap hmConfigurationSavedTrap together with the information
about the AutoConfiguration Adapter (ACA), if one is connected. When you
change the configuration for the first time after saving it, the device sends a
trap hmConfigurationChangedTrap.
RM GUI L2E
47
Release 8.0 05/2013