Removing A Filter From A Ring Port; Deleting A Filter - Alcatel-Lucent 7705 Configuration Manual

Filter Management Tasks

Removing a Filter from a Ring Port

To remove a VLAN filter from a ring port, enter the following CLI command. Including
filter-id is optional because only one filter can be applied to a port.
CLI Syntax:
Example:

Deleting a Filter

After you have removed the filter from all the network interfaces, SAPs, and SDPs (spoke
and/or mesh) where it was applied, use the following CLI syntax to delete the filter:
CLI Syntax:
CLI Syntax:
CLI Syntax:
CLI Syntax:
Example:
322
config>port>ethernet# no vlan-filter [filter-id]
config>port>ethernet# no vlan-filter 2
config>filter# no ip-filter filter-id
config>filter# no ipv6-filter ipv6-filter-id
config>filter# no mac-filter filter-id
config>filter# no vlan-filter filter-id
config>filter# no ip-filter 2
config>filter# no mac-filter 55
7705 SAR OS Router Configuration Guide