Table 37 Show Router Status Output Fields - Alcatel-Lucent 7705 Configuration Manual

tunnel-table
Syntax tunnel-table [ip-address[/mask]] [protocol protocol | sdp sdp-id] [summary]
Context show>router
Description This command displays tunnel table information.
Note that auto-bind GRE tunnels are not displayed in the show command output. GRE tunnels are not
the same as SDP tunnels that use the GRE encapsulation type.
Parameters ip-address/mask — displays the specified tunnel table's destination IP address and mask
protocol — displays LDP protocol information
sdp-id — displays information about the specified SDP
summary — displays summary tunnel table information
Output
The following output is an example of tunnel table information, and
7705 SAR OS Router Configuration Guide
Table 37: Show Router Status Output Fields
Label
Router
OSPFv2-0
RIP
ISIS
MPLS
RSVP
LDP
BGP
Max IPv4 Routes
Max IPv6 Routes
Total IPv4 Routes
Total IPv6 Routes
ECMP Max Routes
Triggered Policies
Description
The administrative and operational states for the router
The administrative and operational states for the OSPF protocol
The administrative and operational states for the RIP protocol
The administrative and operational states for the IS-IS protocol
The administrative and operational states for the MPLS protocol
The administrative and operational states for the RSVP protocol
The administrative and operational states for the LDP protocol
The administrative and operational states for the BGP protocol
The maximum number of IPv4 routes configured for the system
The maximum number of IPv6 routes configured for the system
The number of IPv4 routes in the route table
The number of IPv6 routes in the route table
The number of ECMP routes configured for path sharing
No — triggered route policy re-evaluation is disabled
Yes — triggered route policy re-evaluation is enabled
IP Router Configuration
Table 38 describes the fields.
197