Alcatel-Lucent 7705 Configuration Manual page 209

protocol-id — specifies the decimal value representing the IP protocol to debug. Common
route-table
Syntax route-table [ip-prefix/prefix-length] [longer]
no route-table
Context debug>router>ip
Description
This command configures route table debugging.
The following adapter cards support the full IPv6 subnet range for IPv6 static routes:
For these cards, the supported route range for statically provisioned or dynamically learned routes is
from /1 to /128.
For all other cards, modules, and ports (including the v-port on the 2-port 10GigE (Ethernet) module),
the supported range for statically provisioned or dynamically learned routes is from /1 to /64 or is /128
(indicating a host route).
Parameters ip-prefix/prefix-length — the IPv4 or IPv6 prefix
longer — specifies that the prefix list entry matches any route that matches the specified ip-prefix
7705 SAR OS Router Configuration Guide
protocol numbers include ICMP(1), TCP(6), UDP(17). The no form of the command
removes the protocol from the criteria.
Values 0 to 255 (values can be expressed in decimal, hexadecimal, or
binary)
keywords: none, crtp, crudp, egp, eigrp, encap, ether-ip, gre, icmp,
idrp, igmp, igp, ip, ipv6, ipv6-frag, ipv6-icmp, ipv6-no-nxt,
ipv6-opts, ipv6-route, isis, iso-ip, l2tp, ospf-igp, pim, pnni, ptp,
rdp, rsvp, stp, tcp, udp, vrrp
* — udp/tcp wildcard
• 6-port Ethernet 10Gbps Adapter card
• 8-port Gigabit Ethernet Adapter card, version 2 and version 3
• 2-port 10GigE (Ethernet) Adapter card (on the v-port)
• 10-port 1GigE/1-port 10GigE X-Adapter card
Values ipv4-prefix
ipv4-prefix-length 0 to 32
Values
ipv6-prefix
ipv6-prefix-length {0 to 128} | {0 to 64 | 128}
and prefix-length values greater than the specified prefix-length
a.b.c.d (host bits must be 0)
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
IP Router Configuration
209