Alcatel-Lucent 7705 Configuration Manual page 129

Configuring the cir-rate is optional. If a cir-rate is not entered, then the cir-rate is set to its default
value (0 kb/s). If a cir-rate has been set and the agg-rate is changed without re-entering the cir-rate,
then the cir-rate automatically resets to 0 kb/s. For example, to change the agg-rate from 2000 to 1500
while maintaining a cir-rate of 500, use the command agg-rate-limit 1500 cir 500.
The no form of the command sets the agg-rate to the maximum and the cir-rate to 0 kb/s.
Default no agg-rate-limit
Parameters
agg-rate — sets the PIR for the aggregate of all the queues on the VLAN bound to the network
cir-rate — sets the CIR for the aggregate of all the queues on the VLAN bound to the network
filter
Syntax filter ip ip-filter-id
filter ipv6 ipv6-filter-id
no filter [ip ip-filter-id |ipv6 ipv6-filter-id]
Context config>router>if>egress
config>router>if>ingress
Description This command associates an IP filter policy with an IPv4 or IPv6 interface. IPv4 filters are supported
on all ingress and egress network interfaces. IPv6 filters are supported on all Ethernet ingress and
egress network interfaces (with null or dot1q encapsulation) and on ingress and egress interfaces on
the 4-port OC3/STM1 Clear Channel Adapter card (with POS encapsulation).
Filter policies control packet forwarding and dropping based on IP match criteria.
The ip-filter-id or ipv6-filter-id must have been preconfigured before this filter command is executed.
If the filter ID does not exist, an error occurs.
Only one filter ID can be specified.
The no form of the command removes the filter policy associated with the IP interface.
Default n/a
Parameters ip-filter-id — the ID for the IPv4 filter policy expressed as a decimal integer. The filter policy
7705 SAR OS Router Configuration Guide
interface. The max keyword applies the maximum physical port rate possible.
Values
1 to 10000000 kb/s, or max
Default max (the default PIR is same as the port egress rate)
interface. The max keyword applies the CIR defined for the physical port.
Values 0 to 10000000 kb/s, or max
Default 0 kb/s
must already exist within the config>filter>ip-filter context.
Values 1 to 65535
IP Router Configuration
129