Alcatel-Lucent 7705 Configuration Manual page 130

IP Router Command Reference
ipv6-filter-id — the ID for the IPv6 filter policy expressed as a decimal integer. The filter policy
queue-policy
Syntax queue-policy name
no queue-policy
Context config>router>if>egress
Description This command specifies the network queue policy that defines queue parameters such as CBS, MBS,
CIR, and PIR rates, as well as forwarding class-to-queue mappings for the shaped VLAN queues. The
network queue policy is defined in the config>qos>network-queue context. Refer to the
7705 SAR OS Quality of Service Guide, "Network Queue QoS Policies", for more information.
The queue-policy command is used to enable and disable network egress per-VLAN shapers on a per-
network-interface basis. If the VLAN shaper is enabled, then a set of network egress queues is created
specifically for the interface, and traffic for that interface is handled by a per-VLAN shaper in the
egress direction. If a queue policy has not been assigned, or if the no queue-policy command is issued,
then the VLAN interface defaults to the unshaped mode and the
values. If the VLAN shaper is disabled for the interface, then the queues created for the interface are
deleted, and traffic goes to the unshaped VLAN aggregate queues that are shared by all other interfaces
(or VLANs).
The no form of this command reverts to the default.
Default "default"
Parameters name — specifies an existing network queue QoS policy name
130
must already exist within the config>filter>ip-filter context.
Values
1 to 65535
Note: For information on configuring IP filter IDs, see Creating an IPv4 or IPv6 Filter
agg-rate-limit
7705 SAR OS Router Configuration Guide
Policy.
is set to its default