Configuring Damping - Alcatel-Lucent 7705 Configuration Manual

Configuring Route Policy Components

Configuring Damping

Observe the following when configuring damping.
Use the following CLI syntax to configure damping:
CLI Syntax:
The following example displays damping configuration command usage.
Example:
442
to
protocol bgp
neighbor 10.10.10.104
exit
action accept
• For each damping profile, all parameters must be configured.
• The suppress value must be greater than the reuse value (see
• Damping is enabled in the config>router>bgp context at the BGP global,
group, and neighbor levels. If damping is enabled but route policy does not specify a
damping profile, the default damping profile is used. This default profile is always
present and consists of the following parameters:
→ half-life: 15 min
→ max-suppress: 60 min
→ reuse: 750
→ suppress: 3000
config>router>policy-options
damping name
config>router>policy-options#
config.router>policy-options#damping damptest123
config.router>policy-options#damping# max-suppress 60
config.router>policy-options#damping# half-life 15
config.router>policy-options#damping# re-use 750
config.router>policy-options#damping# suppress 1000
config.router>policy-options#damping# exit
config.router>policy-options#
half-life minutes
max-suppress minutes
reuse integer
suppress integer
7705 SAR OS Router Configuration Guide
Figure 18).