Alcatel-Lucent 7705 Configuration Manual page 244

VRRP Command Reference
VRRP Priority Control Event Policy Commands
policy
Syntax policy policy-id [context service-id]
no policy policy-id
Context config>vrrp
Description This command creates the context to configure a VRRP priority control policy that is used to control
the VRRP in-use priority based on priority control events. The VRRP priority control policy
commands define policy parameters and priority event conditions.
The virtual router instance priority command defines the initial or base value to be used by non-owner
virtual routers. This value can be modified by assigning a VRRP priority control policy to the virtual
router instance. The VRRP priority control policy can override the base priority setting to establish the
actual in-use priority of the virtual router instance.
The policy command must be created first, before it can be associated with a virtual router instance.
Because VRRP priority control policies define conditions and events that must be maintained, they can
be resource-intensive. The number of policies is limited to 1000.
The policy IDs do not have to be consecutive integers. The range of available policy identifiers is from
1 to 999.
The no form of the command deletes the specific policy ID from the system.
The policy ID must be removed first from all virtual router instances before the no policy command
can be issued. If the policy ID is associated with a virtual router instance, the command fails.
Default n/a
Parameters policy-id — specifies the VRRP priority control ID that uniquely identifies this policy from any
service-id — specifies the service ID to which the policy applies. A value of 0 means that this
244
other VRRP priority control policy defined on the system. Up to 1000 policies can be defined.
Values 1 to 999
policy does not apply to a service but applies to the base router instance.
Values
1 to 2147483647
7705 SAR OS Router Configuration Guide