Filter Management Tasks; Renumbering Filter Policy Entries - Alcatel-Lucent 7705 Configuration Manual

Filter Management Tasks

Filter Management Tasks
This section discusses the following filter policy management tasks:

Renumbering Filter Policy Entries

The 7705 SAR OS exits the matching process when the first match is found and then executes
the actions in accordance with the specified action. Because the ordering of entries is
important, the numbering sequence can be rearranged. Entries should be numbered from the
most explicit to the least explicit.
Use the following CLI syntax to resequence existing IP, MAC, and VLAN filter entries:
CLI Syntax:
Example:
CLI Syntax:
Example:
CLI Syntax:
Example:
314
• Renumbering Filter Policy Entries
• Modifying an IP Filter Policy
• Modifying a MAC Filter Policy
• Modifying a VLAN Filter Policy
• Removing and Deleting a Filter Policy
config>filter
ip-filter filter-id
config>filter>ip-filter# renum 10 15
config>filter>ip-filter# renum 30 40
config>filter>ip-filter# renum 40 1
config>filter
ipv6-filter ipv6-filter-id
config>filter>ipv6-filter# renum 10 15
config>filter>ipv6-filter# renum 30 40
config>filter>ipv6-filter# renum 40 1
config>filter
mac-filter filter-id
config>filter>mac-filter# renum 10 15
config>filter>mac-filter# renum 30 40
config>filter>mac-filter# renum 40 1
renum old-entry-id new-entry-id
renum old-entry-id new-entry-id
renum old-entry-id new-entry-id
7705 SAR OS Router Configuration Guide