Alcatel-Lucent 7705 Configuration Manual page 144

IP Router Command Reference
entry
Syntax entry entry-id [create]
no entry entry-id
Context config>router>zone>nat>pool
Description This command configures a NAT pool entry.
The no form of this command deletes the entry with the specified ID. When an entry is deleted, all
configuration parameters for the entry will also be deleted.
Parameters entry-id — the entry ID number
name
Syntax name pool-name
no name
Context config>router>zone>nat>pool
Description This command configures a zone pool name. Pool names must be unique within the group of pools
defined for a zone. It can be used to refer to the pool under configure, show, and clear commands.
The no form of the command removes the name.
Parameters pool-name — specifies the name of the pool. If the string contains special characters (#, $, spaces,
ip-address
Syntax ip-address ip-address [to ip-address] interface ip-int-name
no ip-address
Context config>router>zone>nat>pool>entry
Description This command configures the source IP address or IP address range to which packets that match NAT
policy are routed using NAT. An interface can also be configured, in which case all packets that match
NAT policy are routed to the interface IP address. If the interface IP address is changed dynamically,
NAT is updated accordingly. Only one IP address can be associated with an IP interface. Source IP
addresses and interfaces cannot be used together in a single NAT pool.
The IP address for the interface must be entered in dotted-decimal notation. The maximum IP address
range limit is 255.
144
Values 1 to 65535
etc.), the entire string must be enclosed within double quotes.
Values 1 to 32 characters (must start with a letter)
7705 SAR OS Router Configuration Guide