Alcatel-Lucent 7705 Configuration Manual page 340

Filter Command Reference
The VLAN filter policy, sometimes referred to as an access control list (ACL), is a template that can
be applied to ring ports on the 2-port 10GigE (Ethernet) Adapter card and 2-port 10GigE (Ethernet)
module. Each ring port can support one VLAN filter, and the same VLAN filter can be applied to both
ring ports. The scope of a VLAN policy is always template.
A VLAN filter policy cannot be applied to any other type of adapter card.
Any changes made to an existing policy, using any of the sub-commands, is applied immediately to all
ring ports where this policy is applied.
The no form of the command deletes the VLAN filter policy. A filter policy cannot be deleted until it
is removed from all the ring ports where it is applied.
Parameters
filter-id — the VLAN filter policy ID number
create — keyword required when first creating the configuration context. When the context is
default-action
Syntax default-action {drop | forward}
Context config>filter>ip-filter
config>filter>ipv6-filter
config>filter>mac-filter
config>filter>vlan-filter
Description This command specifies the action to be applied to packets when the packets do not match the specified
criteria in all of the IP, MAC, or VLAN filter entries of the filter.
Default
drop
Parameters drop — specifies that all packets will be dropped unless there is a specific filter entry that causes
forward — specifies that all packets will be forwarded unless there is a specific filter entry that
340
Values 1 to 65535
created, you can navigate into the context without the create keyword.
the packet to be forwarded
causes the packet to be dropped
7705 SAR OS Router Configuration Guide