Alcatel-Lucent 7705 Configuration Manual page 120

IP Router Command Reference
Parameters policy-name — the route policy statement name. Allowed values are any string up to 32 characters
qos
Syntax qos network-policy-id
no qos
Context config>router>interface
Description This command associates a network Quality of Service (QoS) policy with an IP interface.
Only one network QoS policy can be associated with an IP interface at one time. Attempts to associate
a second QoS policy return an error.
Packets are marked using QoS policies on edge devices. Invoking a QoS policy on a network port
allows for the packets that match the policy criteria to be remarked.
The no form of the command removes the QoS policy association from the IP interface, and the QoS
policy reverts to the default.
Default qos 1 — IP interface associated with network QoS policy 1
Parameters
network-policy-id — the network policy ID to associate with the IP interface. The policy ID must
remote-proxy-arp
Syntax [no] remote-proxy-arp
Context config>router>interface
Description
This command enables remote proxy ARP on the interface, allowing a router on one network to
respond to ARP requests intended for another node that is physically located on another network. The
router effectively pretends to be the destination node by sending an ARP response to the originating
node that associates the router's MAC address with the destination node's IP address (acts as a proxy
for the destination node). The router then takes responsibility for routing traffic to the real destination.
Default no remote-proxy-arp
120
long composed of printable, 7-bit ASCII characters. If the string contains special characters
(#, $, spaces, etc.), the entire string must be enclosed within double quotes. The policy
statement must already be defined.
already exist.
Values
1 to 65535
7705 SAR OS Router Configuration Guide