Removing A Filter From A Network Interface - Alcatel-Lucent 7705 Configuration Manual

The following example is for VPLS. A VPRN example includes the interface command
(config>service>vprn>interface).
Example:

Removing a Filter from a Network Interface

To remove an IPv4 or IPv6 filter from a network interface, enter the following CLI
commands:
CLI Syntax:
Example:
7705 SAR OS Router Configuration Guide
config>service# vpls 5000
config>service>vpls# sap 1/1/2
config>service>vpls>sap# ingress
config>service>vpls>sap>ingress# no filter ip 232
config>service>vpls>sap>ingress# exit
config>service>vpls>sap# exit
config>service>vpls>spoke-sdp 15:5001
config>service>vpls>spoke-sdp# ingress
config>service>vpls>spoke-sdp>ingress# no filter mac 55
config>service>vpls>spoke-sdp>ingress# exit
config>service>vpls>spoke-sdp# exit
config>service>vpls>mesh-sdp 15:5000
config>service>vpls>mesh-sdp# ingress
config>service>vpls>mesh-sdp>ingress# no filter mac 54
config>router# interface ip-int-name
egress
no filter [ip ip-filter-id | ipv6 ipv6-filter-
id]
ingress
no filter [ip ip-filter-id | ipv6 ipv6-filter-
id]
config>router# interface b11
config>router>if# egress
config>filter>if>egress# no filter ip 12
config>router>if>egress# exit
config>filter>if># ingress
config>filter>if>ingress# no filter ip 2
config>filter>if>ingress# exit
Filter Policies
321