Parameter Tables Of The Tool Data - Siemens SINUMERIK 802D sl Programming And Operating Manual

Name
_GC_FWEG
_GC_SEARCHS
_GC_SEARCH
_GC_SEARCHSET
_GC_SEACRHVALUE[
0..2]
_GC_SUGFEED
_GC_MF[18]
_GC_MF[19]
Note
The values stored as the default must be checked by the machine manufacturer and
adapted to the realities of the machine.
A.2

Parameter tables of the tool data

The following parameters, operated from the HMI, are available for the tool offsets.
Table A- 1
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Tx
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Type Default
Value
REAL
Grinding wheel data, x=[1...n] y=[1...6]
TPG1 INT
TPG2 INT
TPG3 REAL
TPG4 REAL
TPG5 REAL
TPG6 REAL
TPG7 REAL
TPG8 REAL
TPG9 INT
TPC1 REAL
TPC2 REAL
TPC3 REAL
TPC4 REAL
TPC5 REAL
Description
Free wheel travel path (measurement control)
Tag for seat regrinding is evaluated by the cycles so that the
individual seat can be identified via a block search.
Tag for seat regrinding is evaluated by the cycles so that the
individual seat can be identified via a block search.
Tag for seat regrinding is evaluated by the cycles so that the axes
can be recalibrated.
Regrinding calibration values
Independent of basic system
0 = GWPS in m/s
1 = GWPS in feed/min
Enable program level abort of CYCLE448
Blocking and resetting of last program level abort
Spindle number
Concatenation rule = 0
Min. wheel diameter
Min. wheel width
Current grinding wheel width
Maximum speed
Maximum GWPS
Angle of inclined wheel
Parameter no. for radius calculation
Wheel type (vertical, inclined, free)
Amount of crown
Dressing amount
Cylindric compensation
GWPS
A.2 Parameter tables of the tool data
Appendix
341