Softkeys And Parameters - Siemens SINUMERIK 802D sl Programming And Operating Manual

Part programming
7.4 Free contour programming
1. Enter the values for the starting point.
1 0
2. Select the approach motion to the start point in input field "Approach start point" with
3. Press the "Accept element" softkey.
7.4.4

Softkeys and parameters

Functionality
Once you have defined the contour start point, you can begin programming the individual
contour elements from the main screen shown below:
Figure 7-11
Individual contour elements are programmed with the vertical softkeys. You assign the
contour element parameters in the relevant input screen.
98
The values must be specified as absolute dimensions (reference dimension).
softkey "Alternative" (or the "Select key").
The approach motion can be changed from G0 (rapid traverse) to G1 (linear
interpolation).
Note
If you have not yet programmed a feedrate in the part program, you can enter a specific
feedrate in the "Free text input" field,
e.g. .
F100
The start point is saved.
You can add the next element using softkey commands (see next section "Define a
contour element").
Define a contour element
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding