Network Operation - Siemens SINUMERIK 802D sl Programming And Operating Manual

Network operation

Introduction
The SINUMERIK 802D sl control system communicates via an RS-232 or network interface
with the PG/PC.
Prerequisites
The RCS802 tool must have been installed on the PC.
Note
The RCS802 tool is part of the toolbox of the SINUMERIK 802D sl and is supplied on a CD.
Ethernet connections
Thanks to the integrated network adapter, the control system is network-capable. The
following connections are possible:
● Peer-to-peer Ethernet: Direct connection between control system and PC using a cross-
● Ethernet network: Integrating the control system into an existing Ethernet network using a
Screened network operation with encrypted data transfer is possible using a SINUMERIK
802D sl specific data transfer protocol. This protocol is used, e.g. for transmitting and
executing part programs in conjunction with the RCS tool.
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
over cable
patch cable.
Note
The Ethernet network function is only available for SINUMERIK 802D sl pro.
11
301