Siemens SINUMERIK 802D sl Programming And Operating Manual page 200

Programming
10.1 Fundamental principles of NC programming
Address Meaning
G41 Tool radius compensation left of contour
G42 Tool radius compensation right of contour
G500 Settable work offset OFF
G54 1st Settable zero offset
G55 2nd Settable zero offset
G56 3rd Settable zero offset
G57 4th Settable zero offset
G58 5th Settable zero offset
G59 6th Settable zero offset
G53 Non-modal skipping of the settable work
offset
G153 Non-modal skipping of the settable work
offset including base frame
G60 * Exact stop
G64 Continuous-path mode
G9 Non-modal exact stop
G601 * Exact stop window, fine, with G60, G9
G602 Exact stop window, coarse, with G60, G9
G70 Inch dimension input
G71 * Metric dimension data input
G700 Inch dimension data input; also for
feedrate F
G710 Metric dimension data input; also for
feedrate F
G90 * Absolute dimension data input
G91 Incremental dimension
G94 * Feed F in mm/min
G95 Feedrate F in mm/spindle revolutions
G96 Constant cutting rate ON
(F in mm/rev., S in m/min)
G97 Constant cutting speed OFF
G450 * Transition circle
G451 Point of intersection
BRISK * Jerking path acceleration
SOFT Jerk-limited path acceleration
FFWOF * Feedforward control OFF
FFWON Feedforward control ON
WALIMON * Working area limitation ON
200
Value assignments Information
8: Settable zero offset
modally effective
9: Skipping of the settable work
offset
non-modal
10: Approach behavior
modally effective
11: Non-modal exact stop
non-modal
12: Exact stop window
modally effective
13: Inch / metr.dimension input
modally effective
14: Absolute / incremental
dimension
modally effective
15: Feedrate / spindle
modally effective
18: Behavior at corners when
working with tool radius
compensation
modally effective
21: Acceleration profile
modally effective
24: Precontrol
modally effective
28: Working area limitation
modally effective
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Programming
G96 S... LIMS=... F...
; applies to all axes activated
via setting data;
values set via G25, G26
Surface grinding