Siemens SINUMERIK 802D sl Programming And Operating Manual page 108

Part programming
7.4 Free contour programming
The sequence of individual actions required to program the contour are listed in the table
below.
Table 7- 1
Operating step
108
Programming example, surface grinding
Softkey
1 "Contour"
"Accept element"
2
"Accept element"
3
"Accept element"
3
"Accept element"
4
"Accept element"
5
"Accept element"
6
"Accept element"
"Accept"
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Parameter
Entering the start point:
Plane selection: G17
Start point:
X: 100
Y: 0
Enter parameters for "Straight
horizontal line" element:
X: 0 abs
Transition to following element:
RND: 20
Enter parameters for "Straight
line in any direction" element:
X: -100 abs
Y: 50 abs
Transition to following element:
RND: 30
Enter parameters for "Straight
line in any direction" element:
X: -200 abs
Y: 0 abs
Transition to following element:
RND: 20
Enter parameters for "Straight
horizontal line" element:
Z: 50 abs
Transition to following element:
RND: 5
Enter parameters for "Straight
vertical line" element:
X: 0 abs
Transition to following element:
RND: 5
Enter parameters for "Straight
horizontal line" element:
X: -300 abs
RND: 0
Surface grinding