Siemens SINUMERIK 802D sl Programming And Operating Manual page 311

11.8 Establish the Ethernet network connection to the control (only with SINUMERIK 802D sl pro)
Table 11- 3
Parameter
DHCP
Computer name
IP address
Subnet mask
Enabling the communication ports
Use the "Service Firewall" softkey to enable or disable communication ports.
To ensure maximum possible safety, all ports not needed should be closed.
Figure 11-11 Firewall configuration
The RCS network requires the ports 80 and 1597 for communication.
To change the port status, select the relevant port using the cursor. Pressing the <Input> key
changes the port status.
Open ports are shown in the check box with a check mark.
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Network configuration required
Explanation
DHCP log: A DHCP server is needed in the network which dynamically
distributes the IP addresses.
When No is selected fixed network addresses will be assigned.
When Yes is selected the network addresses are assigned dynamically. Input
fields that are no longer needed will be hidden.
If you selected "yes", the following steps are necessary to activate the fields for
the computer name, IP address and Subnet mask:
1. Press the vertical softkey "Save".
2. Switch the control system off and on again.
Name of the control system in the network
Network address of the control system (e.g. 192.168.1.1)
Network identification (e.g. 255.255.252.0)
Network operation
311